X7E1 And X7E2: Plug-In Connector Assignment For Ethernet Interface (Coding D), M12, 4-Pin, Socket; Led Status Indicators - Bosch rexroth HS5E Instruction Manual

LED Interface
1 X7E1
2
Electronics-
3
module
4
Module status
X7E2
5
6
Table 18: Indicators of status LED
Module status Indicator status
LED (LED 4)
Off no voltage supply
Green/red flashing Self-test
Green flashing Drive ready for
operation
Green in control
Red flashing Warning
Red
Installation | A4... with HS5E(V)(L) control system Series 1x and 30
7.6.5 X7E1 and X7E2: Plug-in connector assignment for Ethernet interface
(coding D), M12, 4-pin, socket
Table 17: Pin assignment of X7E1 and X7E2:
Pin Assignment
1 TxD +
2 RxD +
3 TxD -
4 RxD -
5 not assigned
Use a shielded bus cable as the data cable. When doing this, the shield should be
connected to the connector housing.

7.6.6 LED status indicators

Sercos EtherNET/IP
Activity Activity
Link Link
S Network status
Module status
Activity Activity
Link Link
Network status
LED
Off
Green
Fault
LEDs 1, 2, 5, and 6 refer to interfaces "X7E1" and "X7E2"
- Link: Cable is plugged in, connection has been established (lit up permanently)
- Activity: Data has been sent/received (flashing)
Module status LEDs 3 and 4 refer to the electronics module
For a detailed description of the diagnosis LEDs, refer to the functional
description of the Rexroth HydraulicDrive.
EtherCAT PROFINET
not used Activity
Link/Activity Link
Network status Network status
Module status Module status
not used Activity
Link/Activity Link
Indicator status
no voltage supply
Operation
RE 92076-01-B/2021-04-22, Bosch Rexroth AG
59/104
1
LEDs
2
3
4
5
6