Washer Operation; Washer Results - Maytag 3RMTW4905TW0 Use & Care Manual Installation Instructions

Automatic washer
Table of Contents

Advertisement

Available languages

Available languages

Dispensers clogged or bleach leaking
Did you follow the manufacturer's directions when adding detergent and fabric softener
to the dispensers (on some models)? Measure detergent and fabric softener. Slowly pour
into the dispensers. Wipe up all spills. Dilute fabric softener in the fabric softener
dispenser.
Did you put powdered or color-safe bleach into the liquid chlorine bleach dispenser (on
some models)? Add powdered or liquid color-safe bleach directly to the basket. Do not
use the chlorine bleach dispenser for color-safe bleach.

Washer Operation

Washer won't run, fill, rinse or agitate; washer stops
WARNING
Electric Shock Hazard
Electrically earth this appliance.
Do not use an extension cord or an electrical portable
outlet device.
Failure to follow these instructions can result in death,
fire or electric shock.
Is the power cord plugged into an earthed socket outlet? Plug power cord into an
earthed socket outlet.
Are you using an extension cord? Do not use an extension cord.
Is the indicator on the Timer knob properly lined up with a cycle? Turn the Timer knob to
the right slightly and pull to start.
Are the water inlet valve filters clogged? Turn off the water and remove inlet hoses from
the washer. Remove any accumulated film or particles. Reinstall hoses, turn on water and
check for leaks.
Are both the hot and cold water taps turned on? Turn on the water.
Is the water inlet hose kinked? Straighten the hoses.
Does the water level seem too low, or does the washer appear to not fill completely? The
top of the agitator is much higher than the highest water level. This is normal and
necessary for clothes to move freely.
Has a household fuse blown, or has a circuit breaker tripped? Replace the fuse or reset
the circuit breaker. If the problem continues, call an electrician.
Is the washer in a normal pause in the cycle? The washer pauses for about 2 minutes
during certain cycles. Allow the cycle to continue. Some cycles feature periods of
agitation and soak.
Is the washer overloaded? Wash smaller loads.
Is the lid open? The lid must be closed during operation. Washer will not agitate or spin
with the lid open.
Washer won't drain or spin
Is the drain hose clogged, or the end of the drain hose more than 244 cm (96") above the
floor? See "Connect Drain Hose" for proper installation of drain hose.
Is the lid open? The lid must be closed during operation. Washer will not agitate or spin
with the lid open.
Is there excessive sudsing? Always measure detergent. Follow manufacturer's directions. If
you have very soft water, you might need to use less detergent.
Washer continues to fill or drain; cycle seems stuck
Is the top of drain hose lower than the water level in washer? The top of the hose must be
higher than the water level in the washer for proper operation. See "Drain System."
Does the drain hose fit too tightly in the standpipe, or is it taped to the standpipe? The
drain hose should be loose yet fit securely. Do not seal the drain hose with tape. The hose
needs an air gap. See "Secure the Drain Hose."
Wash/Rinse temperature not what I selected
Are the hot and cold water inlet hoses reversed? See "Connect the Inlet Hoses" for more
information. As your frequency of loads washed increases, the water temperature may
decrease for hot and warm temperatures. This is normal.

Washer Results

Load too wet
Did you use the right cycle for the load being washed?
Select a cycle with a higher spin speed (if available).
Did you use a cold rinse? Cold rinses leave loads wetter than warm rinses. This is normal.
Residue or lint on load
Did you sort properly? Sort lint givers (towels, chenille) from lint takers (corduroy,
synthetics). Also sort by color.
Did you overload the washer? The wash load must be balanced and not overloaded.
Clothes should move freely. Lint can be trapped in the load if overloaded. Wash smaller
loads.
Did you select the correct water level? The water level should be correct for the load
size. Clothes should move freely in the water.
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

3umtw5755tw13rmtw4905tw13rmtw4905tw23umtw5955tw1

Table of Contents