Bosch HDIP056U User Manual page 36

en-us Troubleshooting
Fault
"E" and a number appears in dis-
play and control beeps
With a new oven there is a strong
odor when oven is turned on
Control does not react when a key
is touched
Warm air or steam escapes from
oven vent
Cooling fan runs even when the
oven is turned off
11.2 Cooktop troubleshooting
Fault
The general electrical system of
the appliance is not working.
The automatic ignition is not work-
ing.
The burner flame is not uniform.
The gas flow is not normal or there
is no gas.
36
Cause and troubleshooting
An electronics fault has occured
Press any button or turn any knob to stop the beeping.
1.
Reset the oven if necessary.
2.
Call an authorized service provider.
3.
This is normal with a new oven and will disappear after a few uses
Operate the self clean mode to burn-off the smell more quickly.
▶
The control is wet or soiled
Clean the control panel an wipe it dry.
▶
The touch keys are not pressed correctly
Press the center of the button.
1.
Use the flat part of your finger.
2.
It is normal to see or feel steam or warm air escaping from the oven vent
CAUTION
The oven vents are important for air circulation. Covering the oven vents will cause
the oven to overheat. Refer to the appliance overview for the location of the oven
vents. → Page 13
▶ Do not obstruct oven vents.
The cooling fan will continue to run, even after the oven has been turned off, until
the oven has cooled sufficiently
This is normal. There is no action required.
▶
Cause and troubleshooting
The fuse is faulty.
Check circuit breaker or fuse box to your house.
1.
Make sure there is proper electrical power to the appliance.
2.
The circuit breaker has tripped.
Check circuit breaker or fuse box to your house.
1.
Make sure there is proper electrical power to the appliance.
2.
The mains plug for the power cord is not plugged in.
Connect the appliance to the power supply.
▶
There has been a power failure.
Check whether the lighting in your kitchen or other appliances in the room are
▶
working.
Food remnants, dirt, or cleaning products are located between the igniters and the
burners.
Clean the space between the igniter and the burner.
▶
Burner parts are wet.
Carefully dry the burner parts.
▶
The burner parts are not positioned correctly.
Position the burner parts correctly.
▶
The appliance is not connected properly to the power supply.
Contact a qualified electrician.
▶
The burner parts are not positioned correctly.
Position the burner parts correctly.
▶
The grooves on the burner are dirty.
Clean the grooves on the burner.
▶
The gas supply is blocked by intermediate gas valves.
Open the gas valves.
▶
The gas cylinder is empty.
Replace the gas cylinder.
▶