Specifications - Makita PC5000C Instruction Manual

ENGLISH (Original instructions)
1-1. Lock lever
1-2. Switch trigger
2-1. Indication lamp
3-1. Base (for PC5001C only)
3-2. Hex wrench
3-3. Front roller
4-1. Hex socket head bolt
4-2. Stock removal amount
5-1. Base
5-2. Hex wrench
5-3. Hex socket head bolt

SPECIFICATIONS

Wheel diameter
Rated speed (n)/No load speed (n
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for planing concrete surfaces.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For Model PC5000C
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : planing concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
6-1. Hex wrench
6-2. Hex socket head bolt
7-1. Same level
7-2. Square or ruler
7-3. Hex socket head bolt
8-1. Raise
8-2. Lower
8-3. Dust cover
8-4. Screw
9-1. Lock nut
9-2. Lock nut wrench
Model
Hole diameter
Spindle thread
)
0
Overall length
Net weight
Safety class
) : 91 dB(A)
pA
) : 102 dB(A)
WA
value (tri-axial vector
2
) : 12.0 m/s
h
2
PC5000C
437 mm
4.0 kg
ENE002-1
For Model PC5001C
ENF002-1
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
determined according to EN60745:
ENG102-3
Work mode : planing concrete
Vibration emission (a
Uncertainty (K) : 2.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENG230-2
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
sum)
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
4
9-3. Diamond wheel
9-4. Shaft lock
13-1. Dust bag
16-1. Dust cover cap
16-2. The whole roller holder
16-3. Hex socket head bolt
16-4. Hex bolt
18-1. Limit mark
19-1. Brush holder cap
19-2. Screwdriver
PC5001C
125 mm
22.23 mm
M14
-1
10000 min
479 mm
5.1 kg
/II
) : 89 dB(A)
pA
) : 100 dB(A)
WA
Wear ear protection
total value (tri-axial
2
) : 12.5 m/s
h
2
ENG102-3
ENG230-2
vector sum)
ENG901-1