Strong Razor Series Installation Manual page 4

Step 2: Mount Arms to TV
1. Determine the diameter of the screw (parts D through H) your
TV requires by carefully trying to hand-thread one into the
threaded insert on the rear of the TV. If there is any resistance,
stop immediately.
2. Thread the screw through the washer (M or N), arm, spacer
(parts I through L), and into the TV.
NOTE: NOTE: Spacers are commonly needed on TVs with curved backs or Spacers are commonly needed on TVs with curved backs or
recessed screw inserts. recessed screw inserts.
3. Ensure the arms are installed flat side to TV and are square to
each other after all screws have been installed (Figure 3).
Step 3: Hang TV on to the Wall Plate
Carefully lift the TV to hook the arms over the top lip of the wall
plate (Figure 4). The bottom of the arms will then rest on the top
edge of the locking mechanism. The locking mechanism can be
released by pulling the pull strings down and allowing the TV to
slide into place. Once you release the pull strings the TV will be
locked. Do not release the TV until it is completely connected to the
wall plate.
NOTE: It is easier to hang the TV if the tilt feature is first expanded so NOTE:
It is easier to hang the TV if the tilt feature is first expanded so
that the hook is extended away from the back of the TV and bracket. that the hook is extended away from the back of the TV and bracket.
Adjustments:
Tilt Adjustment
Turn Tilt Adjustment Bolt (Figure 5) clockwise to tighten grip;
counter-clockwise to loosen grip.
Post-Install Level Adjustment
If display is not horizontally level when mounted, adjustment
screws are included at the top of each arm for micro-adjustments
(Figure 6). Use the provided hex wrench (O) to raise or lower the
screw and adjust the mount accordingly.
Up and Out Adjustment (Fixed Only)
Fixed mounts include an Up and Out feature for easy access to ports Fixed mounts include an Up and Out feature for easy access to ports
on the sides and back of displays. To get the most adjustment out of on the sides and back of displays. To get the most adjustment out of
this feature be sure to pull the display toward you and directly away this feature be sure to pull the display toward you and directly away
from the wall (Figure 7). from the wall (Figure 7).
NOTE: NOTE: Take caution to avoid slips or drops. Take caution to avoid slips or drops.
Lifetime Limited Warranty
Strong™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and Strong™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and
labor repairs on all components found to be defective in material or workmanship labor repairs on all components found to be defective in material or workmanship
under normal conditions of use. This warranty shall not apply to products which have under normal conditions of use. This warranty shall not apply to products which have
been abused, modified or disassembled. Products to be repaired under this warranty been abused, modified or disassembled. Products to be repaired under this warranty
must be returned to SnapAV or a designated service center with prior notification and must be returned to SnapAV or a designated service center with prior notification and
an assigned return authorization (RA) number. an assigned return authorization (RA) number.
For Technical Support call 1.866.838.5052
Figure 3
Figure 4
Mount Arm
Figure 5
TV Side
Fixed Mount
Figure 6
Figure 7
Pull out and
away from
the wall
© 2020 STRONG™
200706-1115
Mount Arms
Wall Bracket
Tilt Adjustment Bolt
(Use Provided Hex Wrench)
Adjustment
Screw
Locking
Tab
OR
TV Side
Tilt Mount