Dry Ironing - Grundig SIS 7040 Instruction Manual

OPERATION _______________________________
Preparation
1 Remove all packaging material, stickers and
protective foil and dispose of them according
to the applicable statutory regulations.
2
Clean the outer parts of the appliance as
described in the section "Cleaning and Care".
3
Place the appliance on an even, stable, dry
and non-slip surface.
4
Place the iron on the surface of the storage
E
base .
Notes
During first use, a slight odour may occur as
a result of manufacturing residues being burnt
off. This is harmless and will only last a short
amount of time. Ensure for sufficient ventilation.
Never immerse the steam ironing station in
water or any other liquid. Do not fill with
vinegar, descaling agents, starch, perfume or
ironing aids into the steam ironing station.
When ironing for the first time, use an old, clean
cloth so that manufacturing residues can be
removed from the soleplate
The water tank can be refilled at any time during
use.

Dry Ironing

1 Place the appliance on an even, dry and non-
slip surface. The non-slip feet
stability of the device.
2
The water tank must remain empty during
C
the dry ironing process; otherwise steam
pressure could build up.
3 Insert the power plug
4
Push the on/off switch
steam ironing station.
- The power indicator
the blue steam button indicator light blinks
P
on LOW .
18
ENGLISH
.
D
U
ensure the
on the wall socket.
B
S
to switch on the
N
lights up red and
5 Depending on the type of fabric, turn the
temperature control dial
following settings:
Nylon, setting 1
Silk setting 1
Wool setting 2
Cotton setting 3
Linen setting 3
Caution
Always read the care label on your garment
before setting the temperature.
- The temperature indicator light
blue. The blue temperature indicator light
remains on whilst the iron is heating
K
up. As soon as the iron reaches the set
temperature, the temperature indicator light
goes off. The temperature indicator light will
go on and off during usage to indicate that
the set temperature is being regulated.
6 The ironing process can begin. Do not press
the steam jet button during dry ironing.
Caution
When taking a break from ironing, always
place the iron back on the thermally insulated
E
storage base . The tip of the soleplate
always be placed on the surface of the storage
base.
7
After the ironing process is complete, place the
iron on the surface of the storage base. Press
and hold down the on/off switch of the steam
ironing station for a few seconds to switch the
steam ironing station off. Set the temperature
control dial to MIN and disconnect the plug
from the power.
G
to one of the



K
lights up
D
must