Things To Prepare; Connection Diagram; Set The Pc's Ip Address In Advance - Canon EOS C300 Mark II Manual

１．IP Streaming ("VLC" Application) Setup

1-1 Things to Prepare

① Canon EOS C300 Mark III/ EOS C500 Mark II (with either the Canon EU-V1 or EU-V2 expansion unit
attached – sold separately).
② PC (with VLC application installed from www.videolan.org)
*Operation checks have been performed with VLC Version 3.0.12.
③ Ethernet cable ×1

1-2 Connection Diagram

Assumed connection format: Canon EOS C300 Mark III/ EOS C500 Mark II + Canon EU-V1 or EU-V2 Expansion Unit
(separately sold accessory) ⇔ Ethernet cable ⇔ PC
Connect (1) Canon EOS C300 Mark III/ EOS C500 Mark II + Canon EU-V1 or Canon EU-V2 Expansion Unit (separately
sold accessory) (2) PC with an Ethernet cable.
(1) C300 Mark III/C500 Mark II + EU-V1 or EU-V2
・We recommend using a category 5e (CAT5c) or higher Ethernet cable that supports gigabit.
*When using a category 5 (CAT5) cable, IP streaming may not be possible in some cases.

2. Set the PC's IP Address in Advance

PC settings:
① Start the PC connected to the network, and go to [Control Panel]
② Select [Network and Internet]
③ Select [Network and Sharing Center]
On the network settings screen, open Properties from the [Local area connection] state.
④ Select Internet protocol 4 (TCP/IPv4)
⑤ Open Properties
Do not select [Obtain an IP address automatically]. Instead, select [Use the following IP address] and set the settings
shown below.
(2) PC
③Ethernet