Table of Contents
Advertisement
Repair Instructions
32
31/32/41/42/43-series
Install the valve cover with new gaskets. Tightening
torque upper valve cover 8 Nm. Socket 10 mm, 13
mm.
33
44/300 series
Install the seal against the valve cover (the O-rings,
washer and spring) on each injector.
80
Applies only to KA(M)D44P-B/44P-C/300
Ensure that the cut out in the sealing washer corre-
sponds to the split pin and the injectors cable termi-
nal (only cylinder 1)
44/300 series
Inspect the valve cover gasket. If it is undamaged
and securely fixed to the cover, the gasket does not
need to be changed. If it needs to be replaced carry
out the following:
Carefully clean the gasket seat. Apply a thin layer of
silicone sealant, part no. 116 1231-4 to the valve hou-
sing. Put the new gasket on and leave the silicone
sealer to harden underneath it before installing the val-
ve housing.
NOTE! Align the gasket joint as in the illustration.
Hide quick links:
Advertisement
Table of Contents
