Whirlpool ADG 4800 Quick Reference Manual
  1. Manuals
  2. Brands
  3. Whirlpool Manuals
  4. Dishwasher
  5. ADG 4800
  6. Quick reference manual
Whirlpool ADG 4800 Quick Reference Manual

Whirlpool ADG 4800 Quick Reference Manual

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
QUICK REFERENCE GUIDE
Before using the dishwasher, you are advised to read the user instructions!
On/Off button
Press the button to switch on the
dishwasher. The indicator light for the last
programme to be selected lights up; at the
end of the cycle the dishwasher emits a
brief audible signal.
Programme selection button
Press this button to select the desired
programme.
The indicator light of the selected
programme illuminates.
Indicator lights
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Add rinse aid
Options
Half load
selector button
Press this button to select the half load
option; the corresponding indicator light
will illuminate. Press the button again to
the deselect the option; the corresponding
indicator light will go out.
The half load function is suitable for
smaller wash loads. The dishes should be
distributed over both racks.
Antibacterial rinse
(Sani Rinse option)
This function adds an antibacterial rinse at
the end of the wash cycle, guaranteeing a
further reduction of bacteria. The indicator
light illuminates when the function is
activated.
If the temperature is not maintained at a
constant level during the antibacterial rinse
programme (e.g. if the door is opened or
there is a power cut), the programme
indicator lights will flash to signal that the
sanitizing effect of the antibacterial rinse is
not guaranteed.
"Delayed start" button
The wash cycle can be programmed to
start after 1-12 hours. The delayed start
can be programmed either before or after
selecting the desired wash programme.
When the door is closed, a pre-wash cycle
is run, after which the delayed start
countdown begins.
Quick Wash
This option, when selected together with
any wash programme (except pre-rinse)
SHORTENS THE DURATION of the
selected wash cycle from a minimum of
10% to a maximum of 55%, depending on
the programme selected.
This function is activated by pressing the
QUICK WASH button after having
selected the desired programme.
Tablets selector
This setting allows you to optimize the
wash cycle in accordance with the type of
detergent used. If you use combined
detergents that combine detergent, rinse
aid and/or salt in 1 tablet
Press the «Antibacterial rinse» + «Quick
Wash» buttons simultaneously (the
«Tablet» indicator light will illuminate). If
you are using a powder or liquid
detergent, the «Tablet» indicator on the
control panel must be off.
D
GB
F
NL
GB

Advertisement

Table of Contents
loading

Related Manuals for Whirlpool ADG 4800

Summary of Contents for Whirlpool ADG 4800

  • Page 1 QUICK REFERENCE GUIDE Before using the dishwasher, you are advised to read the user instructions! On/Off button If the temperature is not maintained at a Press the button to switch on the constant level during the antibacterial rinse dishwasher. The indicator light for the last programme (e.g.

  • Page 2: Fault Indicators

    Fault indicators Indicator lights Blinking The water stop device has been activated Switch off the appliance and contact After-Sales Service. The dishwasher has filled with too much water Reset and start the programme again from the beginning. If the problem persists, contact the After-Sales Service.
  • Page 3 Programme Table Detergent Consumption Programmes Loading tips Litres Minutes Dishes to be washed Pre-wash cold 0.02 later. Lightly soiled items, Delicate 45°C 1.10 with no dried-on food. Light soiling, for Rapid 38°C example glasses and 0.85 cups. 50°C Normally soiled items. 1.03 Normally soiled items, Eco fast...

  • Page 4: How To Use The Appliance

    HOW TO USE THE APPLIANCE Further indications are given in the individual chapters and in the user instructions. Open the door Press the On/Off button. Large compartment A How to fill the detergent dispenser Small compartment B Mechanical indicator C. Check the rinse aid level Electric indicator on control panel (if provided).

  • Page 5: Loading The Dishwasher Racks

    LOADING THE DISHWASHER RACKS Upper rack: depending on the model Cup support racks (A): Depending on the position, raise or lower the racks. Place the glasses in the middle and to the right, dishes to the left, under the cup support racks. Place long and narrow utensils (carving forks, knives) on the bottom of the rack, not...

  • Page 6: Cutlery Basket

    Cutlery basket: The cutlery basket has removable inserts into which cutlery should positioned far enough apart so that water can flow between the items. The cutlery basket inserts and central cover can be found in the bag containing accessories. The central cover is simply a lid for the cutlery basket. The inserts can be removed and used separately.
  • Page 7 WHAT TO DO IF... If a fault occurs, before contacting our After-Sales Service, check the following troubleshooting guide to try and remedy the problem (*see also the corresponding chapter in the user instructions). Problem Cause Remedy The appliance is not •...
  • Page 8 Deposits on dishes • can be removed • Streaks on the dishes/glasses. • Reduce the rinse aid setting *. • Layer of salt on dishes/glasses. • Close the salt container lid properly *. • not removable • Insufficient water softening, calcium •...

Table of Contents