Switching on
F Press the end of the control stalk: the
speed limiter mode is selected but is not
switched on.
F Switch the speed limiter on by pulling the
control stalk towards you, if the speed
displayed is suitable (by default, the last
speed programmed).
Pause
F You can temporarily stop the speed limiter
by pulling the control stalk towards you
again: the display confirms that it has been
stopped (Pause).
F Pull the control stalk towards you again to
restore the speed limiter.
Adjusting the speed limit
setting
You do not have to switch the speed
limiter on in order to set the speed.
Once the function is selected, you can modify
the speed setting by:
-
by pushing the control stalk up to increase
the setting,
-
by pushing the control stalk down to
decrease the setting.
A brief push on the control stalk modifies the
speed setting by + or - 1 mph (km/h).
A maintained push on the control stalk modifies
the speed setting by + or - 5 mph (km/h).
Driving
4
87