Advertisement
3- Install the sensor. See figure 4 for 092-152 units and
figure 5 for 156-360 units. Secure sensor with two
#10X5/8" sheet metal screws.
Note - Make sure the air velocity sensor is aligned
ALIGN TEMPLATE
WITH HOLES
POSITION TEMPLATE - 156-360 UNITS
TEMPLATE
ALIGN HOLES ON
TEMPLATE WITH
HOLES IN UNIT
3/32"
3/32"
1"
FIGURE 3
parallel with the air stream.
POSITION TEMPLATE - 092-152 UNITS
BRACKET PROVIDED ONLY
ON UNITS EQUIPPED WITH
A DDC CONTROL
FIGURE 2
Page 2
4- Coil excess probe cable and secure to low voltage
harness with wire tie.
TEMPLATE
092-150 UNITS
SENSOR
A24
CONTROL
FIGURE 4
3/32"
1"
3/32"
Advertisement
