(C) Automatic Zone Registration Using The System Controller - Panasonic CZ-64ESMC2 Instructions Manual

(c) Automatic zone registration using the system controller

(1) Press the and
seconds.
and CODE No. C1 will fl ash.
(2) Select CODE. No. C2 by pressing
press the button.
C2 changes from fl ashing to ON state and automatic zone
registration will start.
(3) Registered GROUP No. will be disappeared all.
(4) Central address will be assigned from small indoor unit address to
large one in numerical order automatically.
Finishing automatic zone registration,
to OFF.
(5) If the error is happened, the "CHECK" starts fl ashing and zone
registration fi nishes at this time. Press the
(6) Finally, complete automatic zone registration mode by pressing the
button.
fl ashes for a few minutes, then OFF.
buttons at the same time for more than 4
and ( ) button and
changes from fl ashing
button.
Fig. 12
EN
17