Preparation Before Use; How To Install The Filters; How To Install Air Purifier; How To Insert Batteries Into The Remote Control - Toyotomi ETK-S50 Instruction Manual

ETK-S50_US_ES.qxd 14.9.9 9:13 ページ 8

PREPARATION BEFORE USE

1

HOW TO INSTALL THE FILTERS

1 1 Pull the front panel toward you and remove it while
pressing the right and left buttons at the bottom of
the main unit.
2 2 Remove the Prefilter.
3 Remove the Semi HEPA filter and activated carbon
3
filter in the bag from the main unit.
4 4 Take the Semi HEPA filter and activated carbon filter
out of the bag and put the thinner activated carbon
filter behind the Semi HEPA filter, then mount the
Semi HEPA filter to the main unit according to the
mounting direction ↑ with the yellow-cloth side to the
front. Mount the Prefilter, too.
5 5 Align the nails located at the top of the front panel to
the main unit, and hang the front panel onto the right
and left hooks at the lower part.
★ If the Semi HEPA filter and activated carbon filter are mounted incorrectly, the filters will not
work properly. Make sure that the yellow-cloth side of the Semi HEPA filter is in front.
★ The Semi HEPA filter should be replaced about five years after opening the package. The
activated carbon filter should be replaced about two years after opening the package. The
replacement frequency depends on how long they are used or where they are installed.
●
The lifetime of the filters will become very short in cases where they absorb oily smoke or
carbonized substances such as soot.
★ Dirty Semi HEPA filter and activated carbon filter cannot be reused even if they are washed.
Be sure to replace them.
8
( Be sure to assemble Filters before using the Air Purifier. )
Button
Prefilter
Hook
NOTE
PREPARATION BEFORE USE
2

HOW TO INSTALL AIR PURIFIER

●
How to effectively install the Air Purifier
Install the Air Purifier in a high place (on a table) when cleaning relatively small-sized dust such as
Heavy smoke. Install the unit in a low place (on the floor) when cleaning large-sized dust such as
pollen.
●
When installing it on the floor or on a table
Place it on the floor or table approximately 30 cm away from
the surrounding walls.
3

HOW TO INSERT BATTERIES INTO THE REMOTE CONTROL

Open the rear cover for batteries by sliding it down and place them
in position. DO NOT place the batteries to the wrong poles ( + and - ) .
NOTE
●
The Remote Control is to be carefully used. If the Remote Control is dropped to the floor or
spilled with water, it may not be able to transmit the signal to the Air Purifier.
●
The maximum signal range is about 7 m ( front ) .
●
If the Remote Control operation does not actuate the Air Purifier, replace both two batteries
( R03 ) D3 with the new ones. If the operation of the Air Purifier is still not normal, remove
batteries and, after an elapse of more than 5 seconds, return them into the Remote Control.
●
The estimated life of the battery is approximately one year, if used with the normal condition,
provided that the battery of which service period is close to "recommended using period"
will have to be replaced shortly.
●
The use of the wrong batteries may cause such dangers as liquid leakage and collapse.
Carefully read the precautions provided on the battery and take special care of the following
points for use.
● Care is to be taken not to mix old and new batteries nor to use the wrong kinds.
If the Remote Control is not used for long time ( more than one month ) , remove the batteries
●
from it. Should any liquid leakage be caused, remove the leakage completely and replace with
the new batteries.
( Choose a place where indoor air circulates well. )
Rear
Cover
9