Advertisement
Available languages
Available languages
User Guide (English)
Introduction
Thank you for purchasing the Total PA
to you. That's why we design our products with one thing in mind—to make your life more fun and
more convenient.
Box Contents
™
Total PA
Prime
Power Cable (5 ft. / 150 cm)
Microphone with cable (15 ft. / 450 cm)
Speaker Stand
Quickstart Guide
Support
For the latest information about this product (documentation, technical specifications, system
requirements, compatibility information, etc.) and product registration, visit ionaudio.com.
For additional product support, visit ionaudio.com/support.
Setup
1.
Make sure all items listed in the
foam sheet for the power cable and microphone.
2.
Read the Safety & Warranty Manual before using the product.
3.
Study the
Connection
4.
Make sure all input devices (such as microphones, CD players, or digital media players) are turned
off with their volume settings set to "zero."
5.
Connect all devices as shown in the Connection Diagram.
6.
Switch everything on in the following order:
a. Audio input devices (e.g. microphones, instruments, CD players)
™
b. Total PA
Prime
7.
When you are finished using Total PA
™
a. Total PA
Prime
b. Audio input devices
Speaker Stand Installation
1. Extend the speaker stand tripod legs on a flat, stable surface. Fully extend the legs until the plastic
bracket is stopped by the bumps on the center pole. Insert the lower pin directly above the lower
adjustment knob and tighten the lower adjustment knob.
2. Raise the mounting pole up to the appropriate height needed and tighten the side adjustment knob.
When raising the mounting pole, make sure the end with the upward pointing arrow is on the top.
3. Insert the upper pin into the upper pin-hole so the mounting pole stays at your set height, and
tighten the side adjustment knob.
™
4. On Total PA
Prime, adjust the bottom knob counter-clockwise so the screw is not blocking the
opening.
5. Line up the Total PA
6. Tighten the mounting knob clockwise on Total PA
Note: Remove Total PA
™
Prime. At ION, your entertainment is as important to us as it is
Box Contents
Diagram.
™
™
Prime mounting hole with the speaker stand pole and place on the pole.
™
Prime prior to moving the stand for maximum safety.
are included in the box. Look in the box under the
Prime, switch everything off in the following order:
™
Prime.
3
Advertisement
