Cord Winder Replacement W/O Disconnecting Everything - Oreck DTX1100 Tune-Up & Service Manual

Increase Quality Through Interaction with the Field
Cord Winder Replacement Without Disconnecting Everything
1. Remove service screw (A)
4. Unhook park (D)
7. Remove 5 screws (G, H, I, J, K) 8. Lift upper housing & unhook (L, M)
This instruction eliminates total disassembly just to replace the cord
winder. Only two leads and a cooling tube to the cord winder need
to be disconnected and reconnected. See the disassembly
instruction to finish the cord winder removal.
A
E
I
M
N
Increase Quality Through Interaction with the Field
2. Lift panel up and pull off right (B)
5. Move circuit board holder (E)
B C
F G
J K
3. Remove circuit board cover (C)
6. Remove cord winder actuator (F)
9. Remove cord winder (N)
D
H
L
24