Included In The Package; Getting Started - VTech Play & Chase Puppy Parents' Manual

INCLUDED IN THE PACKAGE

• Play & Chase Puppy
• Parent's Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child's safety.
NOTE
Please save this parent's guide as it contains important information.
Removing the Packaging Locks
NOTE
Please cut and discard the plastic strap that attaches the
Play & Chase Puppy to the box. The strap is not part of this toy
and should be discarded for your child's safety.

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the two battery covers located on the bottom of the unit, use a
screwdriver to loosen the screws and then open the battery covers.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 4 new AA batteries following the
diagram inside the battery boxes. (For
best performance, alkaline batteries
or fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery covers and tighten
the screws to secure.
Rotate the packaging locks anticlockwise
90 degrees.
Pull out the packaging locks and discard.
4