Philips SD-4.00SA CH Service Manual page 9

4.1.1 Dismantling of DVD Mono Board
1. See Figure 4-1 for dismantling of DVD module.
2. Unlock the OPU conn 1100, Sledge motor conn 1301
and disc motor conn 1300 and remove the Flex
connections.
3. Remove the wire connection to Tray motor conn 1302.
4. Remove 4 screws 10 to 13.
5. Remove the Mono Board
Note: Flex cables are very fragile,care should be taken during
dismounting and when mounting,ensure that Flex cables are
inserted properly into the Flex socket and locked.
4.1.2 Opening of Tray Manually
Figure 4-2
Figure 4-3
It is possible to open the tray manually by moving the Slider in
the position as shown in Figure 4-2 and Figure 4-3
When the slider A is not accessible when a disc is loaded,
unlock the tray by pressing the slider B inward as shown in
Mechanical Instructions
CL 06532147_002.eps
151100
CL 06532147_003.eps
151100
SD-4.00SA_CH
Figure 4-3.The Tray is now disengaged and can be pulled
outwards.
When no disc is loaded, unlocking the Tray can also be done
by moving the Slider A in the direction as shown in Figure 4-4
and pull the Tray outwards.
Figure 4-4
4. EN 9
CL 06532147_043.eps
231100