Markings On Tool; Description (Fig. A); Assembly And Adjustments - Stanley Fatmax SFMCPS620 Instructions Manual

English
1 Instruction manual
1 Li-Ion battery pack**
1 Li-Ion battery charger**
**Included with SFMCPS620M1 Only
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual
prior to operation.

Markings on Tool

The following pictograms are shown on the tool:
Read instruction manual before use.
Wear eye protection.
Wear ear protection.
Do not leave in rain.
Wear head protection.
Wear protective gloves.
Cut hazard. Keep fingers away from slot.
Wear protective footwear.
Rotational direction of the saw chain.
Electrocution hazard. Keep at least 10 m away from
overhead lines.
Switch the tool off. Before performing any maintenance
on the tool, remove the battery from the tool.
Directive 2000/14/EC guaranteed sound power.
94
Keep bystanders away.
Keep bystanders away.

Description (Fig. A)


WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Handle assembly
1
Center extension pole
2
Saw head assembly
3
Trigger switch
4
Lock button
5
Battery
6
14
Foam gripper
7
Threaded pole
8
Threaded sleeve
9
Bar clamp
10
Sprocket cover
11
Hex head screws
12
Guide bar
13
Saw chain
14
Scabbard
15
Intended Use
This pole saw is ideal for pruning applications and cutting limbs
up to 203 mm in diameter.
DO nOT use under wet conditions or in the presence of
flammable liquids or gases.
This pole saw is a professional power tool.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.

WARNING:Use only STANLEY FATMAX battery packs
and chargers.
Inserting and Removing the Battery Pack
from the Tool (Fig. B)
nOTE: Make sure your battery pack
To Install the Battery Pack into the Tool Handle
1. Align the battery pack
handle (Fig. B).
2. Slide it into the handle until the battery pack is firmly seated
in the tool and ensure that you hear the lock snap into place.
To Remove the Battery Pack from the Tool
1. Press the release button
out of the tool handle.
2. Insert battery pack into the charger as described in the
charger section of this manual.
Fuel Gauge Battery Packs (Fig. B)
Some STANLEY FATMAX battery packs include a fuel gauge
which consists of three green LED lights that indicate the level of
charge remaining in the battery pack.
To actuate the fuel gauge, press and hold the fuel gauge
button . A combination of the three green LED lights will
27
illuminate designating the level of charge left. When the level of
charge in the battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to be recharged.
Hex wrench
16
Oil bottle
17
Branch removal hook
18
is fully charged.
6
with the rails inside the tool's
6
and firmly pull the battery pack
24