Advertisement
MU128
Battery Low!
Check Sum ERROR!
HOST Is Offline!
Illegal Data!
MIDI Buffer Full!
No Parameter
No RecallPerform!
Not Available
Not Available with PLG
PB Com ERROR!
Rcv CH Is OFF!
Select BANK Or PGM# First
Select drumS1•¨4 When You Edit
SysEx Adrs ERROR!
SysEx Data ERROR!
SysEx Size ERROR!
This Parameter Isn' t Excl Data
28
The battery voltage (for internal memory backup) may be too low. Replace the battery with the
new one.
The checksum of the received System Exclusive message is incorrect. Check the size of the
checksum of the message and transmitting again.
This message appears when the host computer is not turned on, the connecting cable is not
properly connected, or the sequencing software is not active.
A data error resulted during reception of MIDI massages. Try transmitting the data again, or
turn the MU128 off and back on again.
Too mach MIDI data is being received by the MU128 at one time. Reduce the amount of data
being sent to the MU128.
The selected parameter cannot be displayed with the show MIDI Data function.
This message appears if you use the Recall function in the Performance Edit mode when there
is no edited performance data to be recalled.
Drum Voices cannot be selected when the Sound Module mode is set to "PFM."
The selected XG Plug-in board does not have Voice for the selected Voice category.
An error occurred in the communication between the MU128 and the XG Plug-in board. Turn
l
off the power and check that the board is properly installed.
The XG Plug-in board was unable to process incoming MIDI data, probably because too
l
much data was received too quickly. If possible, avoid sending unnecessary data and
reduce the amount of data sent to the MU128.
The selected parameter for use with the Show MIDI Data function cannot be converted to a
MIDI message value since the Receive Channel for the Part is off. Set the Receive Channel to
an appropriate value.
This message appears if you use the Show MIDI Data function when the Sound Module mode
is set to "PFM" and both the bank number and program number are selected by the cursors.
(The Show MIDI Data function cannot display both values simultaneously.) Move the cursor to
one parameter or the other (bank number or program number) and use the Show MIDI Data
function to check each value individually.
This message appears if you attempt to edit a Drum Voice for a Part whose Part mode has
been set to "drum." Set the part mode to one of the drum setups ("drumS1-S4") in order to edit
the Drum Voice.
The data of the received System Exclusive message is incorrect. Check the address of the
message and try transmitting again.
The data of the received System Exclusive message is incorrect. Check the data of the
message (as to whether it requires an MSB or LSB header) and try transmitting again
The data of the received System Exclusive message is incorrect. Check the size of the
message and try transmitting again.
The selected parameter cannot be displayed with the Show MIDI Data function.
Advertisement
