Table of Contents
Advertisement
Connections
Connect the AC power plug
Connect the AC power plug to an AC wall socket.
Connect the ground wire (GND) to "GND" of the amplifier or receiver.
Note:
Be sure to connect the ground terminal firmly to the amplifier or
receiver. If this connection is not made or is loose, a power source
" H U M " will result.
Placement
Place the unit In a stable and horizontal position, where there is
little or no vibration.
Locate the unit as far away from the speakers as possible and
isolate the unit from sound radiation from them.
Do not place the unit where it Is exposed to direct sun, dust,
moisture or heat.
Keep It in a well ventilated place.
When a radio is placed too close to the turntable and Is played
while the turntable is In operation, Interference with AM recep-
tion may result.
How to operate
1. Set the Power switch/pitch lock knob to the "on" position.
(See Fig. 5.)
The revolutions are indicated at 33 (33-1/3 rpm.) of the speed
knob and digital speed indicator. (Fig. 6.)
Fig. 6
O U A f T T Z
m i e
S P - 1 5
Upon setting the power switch/pitch lock knob to "on", the speed is
changed over to 33-1/3 rpm. at all times.
If the record to be played is other than a 33-1/3 rpm., depress the
speed select button to suit the phono disc to be played.
When the power switch/pitch lock knob is set to "pitch lock", the pitch
control button and speed select button are locked so as not to be
actuated even if the buttons are accidentally touched during playing
(See Fig. 7.)
Therefore, for selecting the speeds or operating the pitch control, first
set the power switch/pitch lock knob to the position "on".
n
n
u.u
pitch
Advertisement
Table of Contents
