Care And Cleaning - Kohler K-3399 Homeowner's Manual

Safety Features (cont.)
Your Kohler toilet is scratch and abrasion-resistant. It is crafted
from a clay mixture that is fired at an intense heat to vitrify the
clay and fuse the glaze. Its surface won't stain, discolor, rust, or
fade. Every component in your Kohler toilet is specifically
designed to increase the toilet's useful life.
The pump and toilets are listed by Underwriter's Laboratory (UL)
for safety. The fill valve is approved by International Association
of Plumbing and Mechanical Officials (IAPMO) for use in this
system.
The pump motor and circuit board are sealed in a housing
separate from the impeller (which propels the water). The motor
turns the impeller by a magnetic coupling. This ensures a
separation between the impeller and the motor with electronic
controls. There are no gaskets or O-rings that can wear out and
allow water to leak into the motor compartment.
Your new Power-Lite toilet is designed to be flushed once every
70 seconds. This feature assures adequate time for the tank to fill
with water and provides consistent operation of the Power-Lite
motor. However, a second flush can be made 35 seconds after the
first flush. If you activate the second flush at this interval, you
must wait 105 seconds to activate a third flush. If you attempt a
third flush before the 105 seconds have elapsed, the toilet will not
flush. This is normal operation.
An overflow slot between the tank and bowl allows water to
drain into the bowl and out the trapway if the water level in the
tank becomes too high.
This toilet is available with an optional cover lock that prevents
unauthorized access to the tank and pump. This instruction is
written under the assumption that the cover lock is present. If
this option was not selected, then ignore steps associated with
cover lock operation.

3. Care and Cleaning

NOTE: See the special instructions below before you clean Artist
Edition products.
Clean the outside surface of your vitreous china toilet with mild soap
and warm water. Wipe the entire surface completely dry with a clean,
soft cloth. You may use soft abrasive cleaners when necessary to clean
your toilet. Do not use strong abrasive cleaners, as they will scratch
and dull the surface. Wipe any splashes of cleaner solutions from
plastic or plated surfaces immediately. Use toilet bowl cleaners on the
Kohler Co. 5 114950-5-A