Whirlpool WFW8620HC Use And Care Manual page 72

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.mx/service
or see the service contact sheet from your country located at the end of this guide.
If you experience
Drying Results
Clothes are not drying
satisfactorily or drying
times are too long
Lint on load
Dried loads are wrinkled
Load too hot
72
Possible Causes
The load is too large and heavy to
dry quickly.
Area under door seal is clogged
with lint.
On some models: Drain pump filter
is clogged with lint.
The load was not removed from
washer at the end of the drying
cycle.
The washer was tightly packed.
Load removed before cool-down
portion of cycle is complete.
Separate the load to tumble freely. Loading drum a quarter full
or less will improve drying performance and cycle time. Run
a high-speed spin cycle.
Gently pull back the rubber door seal and clean lint with the
textured side of an affresh
®
On some models: Clean the drain pump filter. See "Cleaning
the Drain Pump Filter/Draining Residual Water." This procedure
should be performed occasionally.
Remove garments promptly at the end of the drying cycle, or use
the FanFresh option.
®
Dry smaller loads that can tumble freely. Loading drum a quarter
full or less will improve drying performance and cycle time.
Results may also vary depending on fabric type.
Allow the drying cycle to complete the cool-down portion of the
cycle before removing the load. If you cancel the cycle before the
cool-down portion of the cycle and immediately remove the load,
it will be very hot.
Solution
Machine Cleaning Wipe.