Screw specifications
M1.6 x L2.5
Go to
https://support.lenovo.com/partslookup
part:
Antenna module
Remove the I/O board bracket (right)
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 28
Step 1.
Remove the two screws that secure the battery pack connector, then detach the battery pack
connector from the system board.
Attention: Use your fingernails to pull the connector to unplug it.
Step 2.
Remove two screws and then remove the right I/O board bracket.
Figure 20. Remove the right I/O board bracket
Screw specifications
M2 x L3
Go to
https://support.lenovo.com/partslookup
part:
I/O board bracket (right)
Remove the I/O board bracket (left)
Make sure the following FRUs (or CRUs) has been removed.
"Remove the lower case" on page 28
Step 1.
Remove the two screws that secure the battery pack connector, then detach the battery pack
connector from the system board.
Attention: Use your fingernails to pull the connector to unplug it.
Number of screws
4
to look up the Lenovo part number of the following replacement
Number of screws
2
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
37