Belkin F5U005 User Manual

USB BusPort Features
Connect 2 USB devices instantly
Supports full 12 Mbps and 1.5 Mbps low speed devices
Automatically detects speeds and connections of devices
Full compliance with USB Specifications
Plug-and-Play
Package Contents
1 Belkin USB
BusPort- 1 User
Manual

System Requirements

Windows" 98
Windows" 98 CD (for driver installations
1 Available PCI Slot
Installing the Belkin USB BusPort (PCI)
/////// I M P 0 R TA N T ///////
1. POWER OFF the computer and DISCONNECT the power
card.
///////IMPORTANT/////// - -
2. Remove the screws that hold the case shell and remove the shell.
3. Touch the metal part of the case to ground yourself. This will discharge any static
electricity which can damage your computer.
4. Locate an available PCI expansion slot. This will be in the area of your computer
where other cards that look similar to the USB BusPort- are installed.
5. Confirm that the USB BusPort- will fit into the available slot you have chosen.
6. Remove the knockout on the back of the PC which corresponds to the PCI slot
you have confirmed as your selection. If there is a screw, place in a safe spot as
you will
be using it to attach the USB BusPort-.
7. Push the BusPort- firmly into the slot. Apply pressure as needed until the edge
connector is completely sealed.
8. Once the BusPort- is fully sealed, the gold edge connectors are completely in the
slot. 9. Now mount the BusPort- with the screw that you previously placed in a safe
place.
10. Replace the computer's shell and screw it in place.
11. Now that the BusPort- is installed you can now replace the power cable. Proceed
to the next section, Installing Software Drivers.
Installing the Software Drivers
When you initially connect your USB Port, Windows" will automatically detect you
have a new device and request the Windows" 98 CD. Following are step by step
instructions on how to install the software drivers.
Step 1. When Windows98 finds the new Hardware (Opt 820861 PCI to USB Open
Host Controller), it will ask you to insert the CD-ROM into the CD drive.
Left click one time on the button that says "OK".
Step 2. If the default path to the Windows" 98 directory on your CD-ROM is
incorrect, you will see a dialog box that states "the file openhci.sys on
Windows" 98 CD-ROM cannot be found." Simply type in the correct path
to your CD-ROM (example
"d:\") drive and left click one time on the button that says "OK". Your
installation of the USB BusPort- is now complete.
FCC/CE Statement
This equipment has been tested and found to comply with the limits for a Class A &
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the product.
• Increase separation between the product and other devices.
• Connect the equipment into an outlet or a circuit different from the one that it is
currently connected.
• Consult dealer or technical support for help.
Belkin Components
Corporate Headquarters - 501 West Walnut Street- Compton - CA -
Phone 310.898 1100 - 800.223.5546 - Fax 310.898.1111
www.belkin.com
(ID 1998 Belkin Components. AJI Rights Reserved.
All Trade Names Are Registered Trademarks Of Respective Manufacture
users Listed. P7251 I
90220