Changing Air Direction; Exhaust Air Vent; Normal Sounds - Hisense AW0621CR1W Use And Installation Instructions

Timer
To set timer for a 1 – 24 hour delay on – off operation:
1. Press TIMER on remote control, LED display on the air
conditioner control panel will flash.
2. Press up or down arrow button to change the delay time from
1 hour to 24 hours.
3. Press TIMER on remote control again for TIMER
confirmation and TIMER indicator light on the air
conditioner control will be on.
4. To cancel the TIMER, press the TIMER on remote and
the TIMER indicator light will be off.
Use the Vertical Level Vane to direct the air right or left. Use the whole cartridge to direct air up, down or straight ahead.
B
Pull out the exhaust air vent control to Open the exhaust air
■
vent and draw stale or smoky air from the room.
Push in the exhaust air vent control to close the exhaust air
■
vent for maximum continuous cooling.
NOTE: The exhaust air vent control is not available for
6K\8K cooling only.
When your air conditioner is operating normally, you may hear
sounds such as:
Droplets of water hitting the condenser, causing a pinging or
■
clicking sound. The water droplets help cool the condenser.
Air movement from the fan.
■
Filter
1. When the Filter indicator light is lit, remove, clean
and replace the air filter. See "Cleaning the Air Filter".
2. Press Power button on the machine, or FILTER
button on remote to reset the filter
and replacing the air filter.
NOTE:
When the light is on, it will remain on for 180
hours or until you press Clean Filter button.

Changing Air Direction

A
A. Vertical Level Vane
B. Cartridge

Exhaust Air Vent

NOTE:
Fan Speed control is operating.

Normal Sounds

■
■
■
12
A
A. Exhaust air vent control
The exhaust air vent control will function only when the
Clicks from the thermostat cycle.
Vibrations or noise due to poor wall or window construction.
A high-pitched hum or pulsating noise caused by the modern
high-efficiency compressor cycling on and off.
after cleaning
,