Installation Of The Plastic Diffuser - Panasonic PAW-FC Installation And Maintenance Manual

maximum height difference of 200 mm from the
top of the unit (See figure).
Non-level installation will cause condensate dripping

7. Installation of the plastic diffuser

Carefully unpack the assembly and check for damage sustained in transit.
Attach the assembly to the unit, fastening it onto its two fixing supports (ref. 1), then locking the four fixing nuts with their spacers
(ref. 3).
CAUTION:
To fasten the frame use only the screws supplied with it.
Ensure that the frame is not distorted by excessive tightening, that it is aligned with the false ceiling and above all that there is a
seal between the air inlet and outlet.
In the drawing gasket "4" prevents return air from mixing with the supply air and gasket "5" prevents the supply air from leaking into
the ceiling void. On completion, the gap between the unit frame and the false ceiling must not be more than 5 mm.
IMPORTANT
Do not flatten or crush the condensate drain pipe
16