Table of Contents
Advertisement
Operation | Automax 100 | Extension module TS-AC E2-M3-1X
Operation
Compromising of the training system, individual components or other assets. Risk
for safe operation of the training system!
Risk of injury or death for operator or third
Chapter
„Safety
instructions" as of page [5] in these operating instructions must
always be observed!
In order to ensure safe operation of the extension module TS-AC E2-M3-1X, the following
conditions must be met:
Assembly has been carried out properly. Refer to chapter „Assembly" as of page [47].
First commissioning was successfully completed. Refer to chapter
of page [53]
For operation, it may be necessary to connect components to the M12 system connectors
(e.g. sensors) or to use additional extension modules.
Information on connection of components to M12 system connectors can be found
in respective exercise instructions (e.g. by Bosch Rexroth Academy)
in the documentation of the component to be connected
in chapter
„System connectors for digital and analog
Information on attachment of further extension modules can be found
in respective exercise instructions by the Bosch Rexroth Academy
in the documentation of the respective extension module
in chapter
„Extension and
9.1
Software description
In this chapter, access to
The web based managment interface for configuration of the bus coupler
The IoT Gateway web based management interface
is described in detail. The web based management interfaces are accessed by entering the
IP addresses of IndraControl PR21 and the bus coupler ETH-BK. The IP addresses used in
the following description are taken from chapter
[54].
The network cables are connected as described in chapter
page [53].
For access to the web interfaces, the extension module must be connected to a voltage
supply. Depending on the used basic module, it must be activated. Additionally, IndraControl
PR21 must be activated.
9.1.1
Web based management of bus coupler ETH-BK
ATTENTION! To configure the bus coupler via the IoT web based managment interface, a
manual IP address assignment must have been performed and saved! This means, that an
IP address has been set via the rotary coding switches „S1" and „S2", and a restart of the
bus coupler has been performed with this switch settings. After that, both rotary coding
switches „S1" and „S2" must have been set to „Remote access", which means both must
have been set to „0". Further information on the functions of the rotary coding switches „S1"
and „S2" can be found at the table
DANGER
modification" as of page [83]
„Setting the IP
„Rotary coding switch
Bosch Rexroth AG | 05.2021 | DOK-SUPPL*-TS-AC E2-M3-ITRS-EN-P
„First
commissioning" as
inputs" as of page [34]
addresses" as of page
„Network cable
connection" as of
functions" on page [25].
61/94
Advertisement
Table of Contents
