What To Do If - AEG FAVORIT 54052VI User Manual

20

What to do if...

3. Remove the flat filter (C) from the bottom
of the appliance.
4. Fully clean the filters with water.
5. Put the flat filter (C) to its initial position.
Make sure that it assembles correctly in
the two guides (D).
6. Put the coarse filter (A) in the microfilter
(B) and push the filters together.
7. Put the filters (A) and (B) in position. Turn
the handle on the microfilter (B) clockwise
until it locks in position.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clogged, remove remaining parts of soil with a thin
pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads or solvents (acetone).
WHAT TO DO IF...
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the service
centre.
With some malfunctions the indicators flash to show an alarm code.
• The programme indicator flashes continuously.
• The end indicator flashes one time intermittently.
• The programme indicator flashes continuously.
• The end indicator flashes two times intermittently.
• The programme indicator flashes continuously.
• The end indicator flashes three times intermittently.
WARNING!
Deactivate the appliance before you do the checks.
Malfunction
The appliance does not fill with
water.
Alarm code
Possible cause
The water tap is blocked or
there is limescale on it.
The water pressure is too low.
Malfunction
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
Possible solution
Clean the water tap.
Contact your local water au-
thority.
D