Panasonic KW1M Eco-Power METER User Manual page 23

Mode1 Setting flow chart
Phase/Wire system setting mode
Press <ITEM/△><SHIFT/▽> to change Phase/Wire system.
System is selected from Single-phase 2-wire ⇔ Single-phase 3-wire ⇔ Three-phase 3-wire
⇔ Three-phase 4-wire.
1P2W
CT type setting mode
Press <ITEM/△><SHIFT/▽> to change CT type.
CT type is selected from 50 ⇔ 100 ⇔ 250 ⇔ 400 ⇔ 5.
50
Primary side current of CT setting mode
Enter primary side current of CT using <ITEM/△><SHIFT/▽>.
If measured CT is 100A/5A, set to 100. If 5A is measured, set to 5.
Voltage range setting mode
Press <ITEM/△><SHIFT/▽> to change voltage range.
Voltage range is selected from 400V ⇔ 200V.
400V
VT ratio setting mode
Enter VT ratio using <ITEM/△><SHIFT/▽>.
If the VT is 440/110, set to " 4.00 ".
Monitor
↓<MODE> (MODE 1 Lighting)
↓ <SET>
1P3W
100
(1～4000, Initial 5)
*It is only when "5A" is selected on CT type setting mode.
＊only AKW1111
(1.00～99.99)
15
3P3W
3P4W(＊)
＊only AKW1111
250
400
200V
KW1M Eco－POWER METER
→
<SET>
→
<SET>
5
→
<SET>
→
<SET>
→
<SET>