Recharging With Solar Panels (Optional); Cold Weather Usage; Recycle - Westinghouse iGen600s User Manual

RECHARGING WITH SOLAR PANELS (OPTIONAL)

Make sure to use panel with 8mm output plug. Place solar panel where it
will get as much direct sunlight as possible. Plug the output of the solar
panel into the input on the back of the power station to start charging. You
will know the unit is charging when the red LED battery indicator is on. The
unit is fully charged when all battery indicators on LED display illuminate.
After the unit is fully charged, please remove the AC wall charger.
NOTICE: When solar recharging your power station, take note of the
voltages of the solar panels and do not exceed 19V. Individual solar panels,
or solar panels chained in series in excess of 19V cannot be used with
the power station and can cause serious damage to the unit. For help on
chaining solar panels, call our Customer Service Center at 1-855-944-
3571.
Back

COLD WEATHER USAGE

Cold temperatures (below freezing) can affect the unit's battery capacity
due to chemical characteristics of the battery. If you'll be living off-grid in
sub-zero conditions, we recommend you keep your unit in an insulated
cooler, and connected to a power source (solar panels). The natural heat
generated by the unit contained in an insulated cooler will keep battery
capacity at its highest.

RECYCLE

Always return your used electronic products, batteries, and packaging
materials to dedicated collection points. This way you help prevent
uncontrolled waste disposal and promote the recycling of materials.
Westinghouse Outdoor Power Equipment - 12