Care And Cleaning - Zanussi ZDS 4010 User Manual

Cancelling a washing programme
1. Press and hold function buttons B and C until all the
programme lights come on.
2. Release function buttons B and C to cancel the wash-
ing programme.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme .
Fill the detergent dispenser with detergent before you set
a new washing programme.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of interrup-
tion.
Setting and starting a washing programme with
delay start
1. Press the on/off button.
2. Set a washing programme.
3. Press the delay start button until the display shows
on flashing the necessary delay start of the washing
programme.
– The delay start indicator light comes on.
4. Close the door.
– The number on the display comes on with fixed
light.
– The countdown of the delay start starts.
– The countdown of the delay start decreases with
steps of 1 hour.
– When the countdown is completed, the washing
programme starts automatically.
Do not open the door during the countdown to pre-
vent interruption of the countdown. When you close

Care and cleaning

Warning! Switch the appliance off before you clean
the filters.
Cleaning the filters
Important! Do not use the appliance without the filters.
Make sure that the installation of the filters is correct.
12
the door again, the countdown continues from the point
of interruption.
Cancelling a delay start:
1. Press and hold function buttons B and C until all the
programme lights come on.
– When you cancel a delay start, you also cancel the
washing programme.
2. Set a new washing programme.
End of the washing programme
• The appliance stops automatically.
• The display shows 0.
1. Switch off the appliance.
2. Open the door.
3. For better drying results, keep the door ajar for some
minutes before you remove the dishes.
Let the dishes cool down before you remove them from
the appliance. Hot dishes are easily damaged.
Standby mode
If you do not switch off the appliance at the end of the
washing programme, the appliance automatically goes
into standby mode. The standby mode decreases energy
consumption.
Three minutes after the end of the programme, all indi-
cator lights go off and the digital display shows one hor-
izontal bar.
Press one of the buttons (not the on/off button), to go back
to end-of-programme mode.
Removing the load
• First remove items from the lower basket, then from
the upper basket.
• There can be water on the sides and door of the appli-
ance. Stainless steel becomes cool more quickly than
the dishes.
Incorrect installation will cause unsatisfactory washing
results and damage to the appliance.