Cover; Care And Maintenance; Harness - Britax Car Sea User Manual

P2219_R02f.qxd 11/7/2002

Care and Maintenance

Cover Removal
1 Loosen the harness, by lifting the harness release lever while pulling
the shoulder straps forward as far as possible.
2 Unhook the shoulder straps from the yoke, on the rear of child
restraint.
3 Pull upper harness straps through the shell and cover, to the front
of the restraint.
4 Remove the belly pad from the buckle.
5 Gently remove the upper portion of the cover. Be careful not to
damage the energy absorbing foam.
6 Pull the lower harness straps, buckle tongues, chest clip, and buckle
through the slots in the cover.
WARNING:
• Do not take apart or attempt to take apart the harness. It is
unnecessary and dangerous to do so.
• Never remove the buckle tongues from the harness. They
cannot be reattached after removal.
7 Remove the entire cover from the restraint.
Refitting the Cover
To refit the cover, reverse Cover Removal directions. Make sure that
the shoulder straps are threaded through the chest clips and that
the harness is not twisted.
24
10:23 AM Page 26
Cleaning the Cover
HAND WASH, using cold water and mild soap.
LINE DRY, to prevent cover from shrinking.
DO NOT:
• Bleach
• Machine wash
• Machine dry
Cleaning the Harness
SPONGE CLEAN, using warm water and mild soap.
TOWEL DRY
DO NOT:
• Bleach
• Machine wash
• Machine dry
• Disassemble the harness
Cleaning the Shell
SPONGE CLEAN, using warm water and mild soap.
TOWEL DRY
DO NOT:
• Use abrasive cleaners
• Disassemble the harness
Care and Maintenance
25