NEC MultiSync EA242F User Manual page 8

Handling the power cord.
Handle the power cord with care. Damaging the cord could lead to fire or electric shock.
•
•
•
•
1
•
•
•
•
Please confirm the distribution system in building installation shall provide the circuit breaker rated
2
120/240 V, 20 A (maximum).
Do not bind the power cord and the USB cable. It may trap heat and cause a fire.
3
Do not climb on the table where the product is installed. Do not install the product on a wheeled table
4 if the wheels on the table have not been properly locked. The product may fall, causing damage to
the product or personal injury.
Installation, removal, and adjustment of the stand.
•
•
5
•
Do not push the product.
6
The product may fall, causing damage to the product or personal injury.
Do not impact the LCD panel surface, it can cause serious damage to the product or personal injury.
7
Suitable for entertainment purposes at controlled luminous environments, to avoid disturbing
8
reflections from the screen.
Do not connect headphones to the product while you are wearing them. Depending on the volume
9
level, it may damage your ears and cause loss of hearing.
When connecting the power cord to the product's AC IN terminal, make sure the connector is
fully and firmly inserted.
Make sure the power cord cannot be easily disconnected.
Do not connect or disconnect the power cord with wet hands.
When connecting or disconnecting the power cord, pull the power cord out by holding onto its
plug.
When cleaning the product, for safety purposes, unplug the power cord from the power outlet
beforehand. Regularly dust off the power cord by using a soft dry cloth.
Before moving the product, make sure the product power is off, then unplug the power cord
from the power outlet and check that all cables connecting the product to other devices are
disconnected.
When you are not planning to use the product for an extended period of time, always unplug the
power cord from the power outlet.
This equipment is designed to be used in the condition of the power cord connected to the earth.
If the power cord is not connected to the earth, it may cause electric shock. Please make sure the
power cord is earthed properly.
Handle with care when pulling the stand as it might pinch your fingers.
Before rotating the screen, disconnect the power cord and all cables from the product. Otherwise,
the power cord or cables might pull with excessive force and cause personal injury or damage to
the product.
When rotating the screen, slide it to the highest level and set it to the maximum tilt. Otherwise, it
could cause personal injury or knock the screen on the desk.
CAUTION
English−6