Baumatic BDF671 Instruction Manual page 30

E3
o Longer heating time- not reaching the required temperature.
Malfunction of the temperature sensor or heating element.
Call Baumatic Service Department.
E4
o The machine has sensed water in the base.
Check that the outlet hose is not kinked or crushed.
Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
E5
o Switch cannot shut off automatically- program not finishing its
cycle.
Low voltage or power switch failure.
Call Baumatic Service Department.
E6
o Open circuit
Thermistor
Call Baumatic Service Department.
E7
o Short circuit
Thermistor
Call Baumatic Service Department.
o Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o Turn the machine on using the ON/OFF button and wait for 5
seconds.
o Switch the appliance back on using the ON/OFF button.
o Wait for a further 5 seconds before attempting to set a wash
program, using the program selection buttons.
IMPORTANT: If any other fault code appears in the
display window, you should not attempt to clear it yourself
and contact the Baumatic Service Department.
30