Related Manuals for Swann activair SAC16810N
Summary of Contents for Swann activair SAC16810N
- Page 1 Portable Air Conditioner Model: SAC16810N Help line 0333 220 6050 SAC16810N_IM.indd 1 27/03/2020 11:11...
- Page 2 IMPORTANT INFORMATION - RETAIN FOR FUTURE USE We encourage you to read this user guide carefully and completely before installing and using your device. It is important that this user guide is kept with the device for any new consultation. If this unit is to be transferred to another person, make sure that the user guide accompanies 1.
- Page 3 IMPORTANT INFORMATION - RETAIN FOR FUTURE USE 12. Check the mains voltage. The air conditioner is only intended for a grounded power outlet with a 220-240 Volt (50 Hz) connection voltage. 13. The appliance must always be connected to a grounded outlet.
- Page 4 IMPORTANT INFORMATION - RETAIN FOR FUTURE USE 21. This appliance is intended for home and domestic use only. WARNING • Do not use any means to speed up the defrosting process or to clean, other than those recommended by the manufacturer.
-
Page 5: Technical Data
IMPORTANT INFORMATION - RETAIN FOR FUTURE USE recognized by industry associations. • Repairs must be made according to the manufacturer’s recommendations. • Maintenance and repairs that require the assistance of other qualified personnel must be performed under the supervision of a person specified in the use of flammable refrigerants. - Page 6 IMPORTANT INFORMATION - RETAIN FOR FUTURE USE Caution: Risk of fire The refrigerant gas User Manual. Identify the contained in the circuit of location where the user this device is isopropane manual is stored or iden- (R290), low pollutant but tify information about the Caution: Risk flammable gas.
-
Page 7: Get To Know Your Product
GET TO KNOW YOUR PRODUCT 1. Control panel 6. Cable rack 2. Cold air outlet 7. Water purge outlet 3. Castors 8. Air inlet grille (evaporator) 4. Handle 9. Hot air outlet 5. Continuous drainage water outlet 10. Air inlet grille (condenser) CONTROL PANEL 1. -
Page 8: Remote Control
GET TO KNOW YOUR PRODUCT REMOTE CONTROL 1. On/off 2. Timer 3. Down button (to lower the temperature or the timer) 4. Mode button to select: COOLING, DEHU- MIDIFYING or FAN mode 5. Up button (to increase temperature or timer). 6. - Page 9 INSTALLATION Connect the connector to the unit by sliding it into the slot on the back of the unit. Unfold the hose to the desired length and then pass the other end of the hose through the win- dow to allow the hot air to escape to the outside.
-
Page 10: Operation
INSTALLATION This length of the hose has been taken into account in the technical specifications of the air conditioner. Therefore, never use an extension hose. OPERATION 1. ON / OFF: The button on the control panel or on the remote control can be used to turn the unit on or put it to standby. - Page 11 OPERATION hose. Adjust the fan speed and the temperature set point according to the ambient temperature. The cooling function turns off when the room temperature is below the set temper- ature. Ventilation, however, continues to operate at the set level. The cooling func- tion starts again as soon as the room temperature exceeds the set temperature.
- Page 12 OPERATION 5. TIMER: To set the timer, press the button on the control panel of the unit or on the remote control. Pressing the “+” or “-” buttons increases or decreases the time by one hour. (1 hour at a time). a) PROGRAMMING THE AUTOMATIC SWITCH OFF : •...
-
Page 13: Cleaning And Maintenance
CLEANING AND MAINTENANCE A. MAINTENANCE OF THE APPLIANCE: • Before any maintenance and cleaning operation, it is ESSENTIAL to disconnect the power cable from the mains for safety reasons. • Do not use chemicals or detergents for cleaning or maintenance of the appli- ance. -
Page 14: Operation Tips
CLEANING AND MAINTENANCE D. IN CASE OF LONG PERIOD OF NON-USE: If you do not plan to use the device for a long time: • Drain the appliance by removing the rubber plug located in the lower part of the appliance (at the back). -
Page 15: Troubleshooting
TROUBLE SHOOTING Problem Possible cause Solution The unit doesn’t operate Check power cord and Replace fuse if necessary. fuse Connect power cord. The device has entered Wait 3 minutes before security mode pressing the On/Off but- ton. If using remote control, Replace batteries check that batteries are not discharged... -
Page 16: Warranty
SPARES The following spares are available via our web site: SAC16810N01 - air filter SAC16810N02 - outlet hose www.swan-brand.co.uk WARRANTY This product is guaranteed for 2 years from the date of original purchase. If any defect arises due to faulty materials of workmanship the faulty products must be returned to the place of purchase. - Page 17 NOTES SAC16810N_IM.indd 17 27/03/2020 11:11...
- Page 18 NOTES SAC16810N_IM.indd 18 27/03/2020 11:11...
- Page 19 NOTES SAC16810N_IM.indd 19 27/03/2020 11:11...
- Page 20 www.swan-brand.co.uk 2 year Est. 1 931 GUARANTEE Scan this QR code We love we’re proud Find us on Facebook to hear about what we do of our quality our story * on selected products Copyright © Swan Products Ltd. PO Box 3117, Stoke-on-Trent ST4 9GD SAC16810N_IM.indd 20 27/03/2020 11:11...