Sound Settings And Setup Menu; Changing The Sound Settings - Sony CDX-GT260MP Operating Instructions Manual

Sound Settings and
Setup Menu
Changing the sound
settings
Adjusting the sound
characteristics
1
During reception/playback, press the
select button.
2
Rotate the control dial until the desired
menu item appears, then press it.
3
Rotate the control dial to select the
setting, then press it.
4
Press (BACK).
The following items can be set:
EQ3 LOW* (page 11)
1
EQ3 MID* (page 11)
1
EQ3 HIGH* (page 11)
1
BALANCE
Adjusts the sound balance: "RIGHT-15
(R15)" – "CENTER (0)" – "LEFT-15
(L15)."
FADER
Adjusts the relative level: "FRONT-15
(F15)" – "CENTER (0)" – "REAR-15
(R15)."
SW LEVEL* (Subwoofer Level)
2
Adjusts the subwoofer volume level:
"+10 dB" – "0 dB" – "–10 dB."
("ATT" is displayed at the lowest
setting.)
AUX VOL* (AUX Volume level)
3
Adjusts the volume level for each
connected auxiliary equipment: "+18
dB" – "0 dB" – "–8 dB."
This setting negates the need to adjust
the volume level between sources.
*1 When EQ3 is activated (page 11).
*2 When the audio output is set to "SUB-OUT"
(page 12).
"ATT" is displayed at the lowest setting, and
can be adjusted up to 21 steps.
*3 When AUX source is activated (page 13).
Customizing the equalizer
curve — EQ3
"CUSTOM" of EQ3 allows you to make
your own equalizer settings.
1
During reception/playback, press
 repeatedly to select
"CUSTOM," then press
2
Press the select button.
3
Rotate the control dial until "EQ3
LOW," "EQ3 MID" or "EQ3 HIGH"
appears, then press it.
4
Rotate the control dial to adjust the
selected item, then press it.
The volume level is adjustable in 1 dB
steps, from –10 dB to +10 dB.
Example: CDX-GT360MP
Repeat steps 2 and 3 to adjust the
equalizer curve.
To restore the factory-set equalizer
curve, press and hold the select button
before the setting is complete.
5
Press (BACK).
(BACK).
11