Table of Contents
Advertisement
Serene HB80/110
Evaporator
Condenser
Figure 3: Condenser Coil
and Compressor (HB80
pictured)
8
Refrigeration System
The evaporator plate is attached to the inside back wall of the cabinet.
The evaporator fan, along with the thermostat and cabinet light switch,
is located inside the cabinet behind the motor support panel.
To access the evaporator fan, thermostat and light switch
1. Isolate the chiller from the power supply.
2. Remove the five screws holding the motor support panel.
3. Swing the motor
support panel down
to access
components.
The condenser coil is attached to the rear of the cabinet. The condenser
coil should be brushed regularly to remove any dust build up.
The compressor is located at the bottom of the cabinet (see Figure 3
below) and is accessed by removing the refrigeration compartment
grille from the rear of the cabinet. The plastic condensate tray lifts off
the compressor for cleaning purposes.
Condenser coil
Condensate tray
Motor support panel
Evaporator plate
T
hermostat
Compressor
Replacement Procedures
Evaporator fan
Light switch
Service Manual
Advertisement
Table of Contents
