Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Serene SC112N-A
Summary of Contents for Serene SC112N-A
- Page 1 SC112N-A SERENE Four Glass Sided Chiller Type: HSC112N from SKOPE...
- Page 2 E-mail: skope@skope.com Website: www.skope.com Trademark Infringement The SERENE trademark on this product is infringed if the owner, for the time being, does any of the following: • Applies the trade mark to the product after their state, condition, get-up or packaging has been altered in any manner •...
-
Page 3: Table Of Contents
Troubleshooting......... 11 SERENE SC112N-A... -
Page 4: Installation
SERENE SC112N-A Installation Safety First Always observe safety precautions when using any electrical appliance. Read these instructions carefully and retain them for future reference. WARNING • Ensure the appliance is disconnected from the power supply before performing any cleaning or maintenance. -
Page 5: Positioning The Fridge
SERENE SC112N-A Positioning the Fridge Climate Class The fridge is designed to operate within a climate class 3 environment (25°C @ 60% RH). Location Select a suitable location for the fridge away from direct sunlight and heat sources e.g. radiators, baseboard heaters, cooking appliances etc. -
Page 6: Operation
SERENE SC112N-A Operation Automatic Start-Up After the fridge has been positioned in a suitable place, plug it in and check the following activity. Item Activity Condenser fan The condenser fan starts immediately and can be heard. Evaporator fan The evaporator fan will start after a few seconds. The... -
Page 7: Electronic Controller
SERENE SC112N-A Electronic Controller Introduction The electronic controller is visible through a cut-out in the front panel. It uses temperature probes and a door switch to collect data and runs the fridge accordingly. The electronic controller can be manually switched between ‘Normal’... -
Page 8: Normal And Energy Saving Modes
SERENE SC112N-A Normal and The electronic controller can be switched between two operating modes: Energy Saving ‘Normal’ mode and ‘Energy Saving’ mode. When in Normal mode, the interior lights are on and the internal temperature is regulated to the setpoint Modes setting (see page 9). -
Page 9: Temperature Setpoint
SERENE SC112N-A Temperature The fridge temperature setpoint is factory set at 2°C for storage of Setpoint perishable products (all shelves maintain temperatures below 5°C). The cabinet setpoint can be adjusted between 0°C and 4°C. SKOPE do not recommend that the setpoint be changed unless it is absolutely necessary, and then only by small increments at a time. -
Page 10: Maintenance
SERENE SC112N-A Maintenance Cleaning Many commercially available cleaning products contain solvents that may damage the plastic components of the fridge and cause them to crack. Do not use abrasive or corrosive cleaners or boiling water. CAUTION Isolate the fridge from the power supply before cleaning. -
Page 11: Troubleshooting
SERENE SC112N-A Troubleshooting For problems with the fridge refer to the following table. Problem Possible Cause Suggestions • Fridge not operating. • Loss of power supply. • Check mains power supply. • Interior lights not on. • Electronic controller • Switch the light on while... - Page 12 SKOPE Industries Limited A.B.N. 73 374 418 306 AU: 1800 121 535 NZ: 0800 947 5673 skope@skope.com www.skope.com...