Table of Contents
Advertisement
•
Plug the mains lead into a 13 Amp mains socket that is
protected by a 30mA Residual Current Device (RCD). Never
use equipment outdoors that is connected to a socket that is
not protected by an RCD.
•
If connecting via an extension lead, make sure that the lead
is rated at 10 Amps or more, and that it is fully unwound.
•
Switch the appliance on at the mains socket.
•
Pull the cord-operated switch to select the required
operation:
Figure "1" displayed = Low Heat (650 W)
Figure "2" displayed = Low Heat (1350 W)
Figure "3" displayed = High Heat (2000W)
•
Do not touch the grille when the appliance is in operation,
because it will be hot and may cause burns.
•
Unplug the appliance from the mains when not in use.
•
To adjust the angle, switch off the appliance and allow it to
cool for 15 minutes. Slacken the pivot screw, and adjust the
reflector to the preferred angle. Re-tighten the screw. The
appliance may now be switched on.
•
To adjust the height, loosen the black locking nut at the top
of the pole, and slide the telescopic section of the pole to the
preferred height. Re-tighten the black locking nut.
When used in an office environment, this product must be
safety-tested yearly by a qualified electrician (PAT Tested) in
order to comply with the Electricity at Work Regulations.
We recommend that it is PAT tested regularly when used in a
domestic environment.
OPERATION
PAT TESTING.
Page 4
Advertisement
Table of Contents
