Sst Switch 3D Gun Assembly - Graco 25T991 Instructions - Parts Manual

Repair
502
503
504
506
505
F . 20
IG

SST Switch 3D Gun Assembly

NOTE: Before assembly, It is recommended to have
Yearly Service Kit, 25U328 on page No. 38. Make sure
parts are thoroughly cleaned. Refer to the fastener
torque settings in the Technical Specifications on
page No. 50. Suitable lubricant and thread locking
compound should also be available.
Swivel Housing Assembly
NOTE: For general sequence of swivel housing
assembly refer to F . 20.
IG
NOTE: Medium strength thread locker used for this
®
assembly is Loctite 242 or equivalent. Anti seize
lubricant used for this assembly is Loctite
equivalent.
1. Insert support ring (510) into the larger bore end of
the swivel housing assembly (511) until the support
ring is square against the internal shoulder.
2. Apply a thin coat of lithium grease onto the outside
of the O-ring on the rotary seal (508). To prevent
damage to the Rotary seal O-ring insert into the
bore of the swivel housing (511) at an angle. Make
sure that the O-ring does not tear against the inlet
opening and push the rotary seal against the
support ring (510). See side view F
20
501
507
508
®
77164 or
. 25.
IG
509
511
F . 21
IG
3. Insert material distributor ring (509) into the bore of
the swivel housing (511). It is recommended to use
the Material Seal Insertion/Removal Tool,
17V972 on page No. 39 and a soft faced mallet.
Push the material distribution ring (509) and rotary
seal (508) fully to the bottom of the bore.
510
511
508
3A8476A
502
510