NAPCO 5831 Operator's Manual page 5

Warnings and Notices
Important: READ THESE NOTICES BEFORE INSTALLING THE UNIT
General Notices
AS A ROUTINE LABORATORY PRECAUTION, ALWAYS WEAR SAFETY GLASSES WHEN
WORKING WITH THIS APPARATUS.
MAINTAIN A MINIMUM OF 12 INCHES CLEARANCE BETWEEN THE OVEN AND ANY
COMBUSTIBLE SURFACES.
HEATERS ARE LOCATED ON BOTTOM OF CHAMBER. PLACING AN ITEM DIRECTLY
ON THE CHAMBER FLOOR MAY CAUSE OVERHEATING OF THE ITEM.
VACUUM PUMPS SHOULD NEVER BE TURNED OFF WHILE CONNECTED TO A SYSTEM
UNDER VACUUM. OIL BACK UP INTO THE LINES AND SYSTEM WILL OCCUR
NECESSITATING EXTENSIVE CLEAN UP.
USE EXTREME CARE MUST BE TAKEN WHEN HANDLING THE CLEANING MATERIALS
LISTED IN THIS MANUAL (SEE PAGES 7 & 8). ALWAYS WORK IN AN AREA WITH
ADEQUATE VENTILATION. USE THE PRECAUTIONS OUTLINED IN THE MATERIAL
SAFETY DATA SHEET (MSDS) AND MANUFACTURER'S INSTRUCTIONS FOR THE
PRODUCT YOU ARE WORKING WITH. FOLLOW THE PERSONAL PROTECTION INDEX
FOUND IN THE HAZARDOUS MATERIALS IDENTIFICATION SYSTEM (HMIS) SECTION
OF THE MSDS.
Electrical Warnings
CHECK VOLTAGE AND WATTAGE STAMPED ON THE DATA PLATE FOR COMPATIBILITY
BEFORE CONNECTING THE OVEN TO ITS POWER SOURCE. THE DATA PLATE CAN
BE FOUND NEAR THE POWER CORD. FIRST ENSURE THAT THE POWER SWITCH IS
IN THE "OFF" POSITION.
UNIT MUST BE DISCONNECTED FROM POWER SOURCE PRIOR TO SERVICING. IT IS
RECOMMENDED THAT ALL SERVICE BE PERFORMED BY QUALIFIED SERVICE
PERSONNEL.
V