B&K Reference 50 Owner's Manual page 71

Set the Zone ID for Zone B - Each message transmitted from your remote includes a Product ID Code Set (See
Zone ID), which allows independent command and control of the processor's Zones A and B. Set the desired
zone ID number for use with Zone B (default 2). You may not set the Zone B zone ID to the same setting as Zone
A (default 1) or vice versa. If you need to set Zone B to the current Zone A setting then you must first set Zone A
to some other Zone ID value.
WARNING - if you change the Zone product ID code set in the processor without making the
corresponding change to the remote then the remote will no longer appear to work. Refer to the separate
remote manual for details on changing the remote's product ID code set ("device code").
From Remote
1 À(UP) or §(DOWN)
2 ¶ •
(LEFT) or (RIGHT)
Set V2 line output usage - V2 output is normally set up as a tape loop. The V2 and Zone 2 (B) output are the
current source (V1, TV, CD, DVD, etc.) except when the current selection is V2. When V2 is selected as the
source, the Zone 2 (B) output is V2 and the V2 output is the previously selected source. This prevents feedback
when the V2 inputs and outputs are connected to a tape deck or VCR. Feedback can cause high frequency
oscillations, which may damage your speakers. If you don't connect a tape deck to the V2 input and output you
can use the V2 output as an additional line out. In this mode V2 output is always the selected input including V2.
ADVANCED ZONE B SETTINGS
1 Level Control
2 Fixed Level
3 Zone ID
4 V2 Output
4 V2 Output
5 Link Input to Zone A
6 Link Power to Zone A
next item
MENU advanced setup
ZB V2 OUT
From Remote
1 À(UP) or §(DOWN)
2 ¶ •
(LEFT) or (RIGHT)
ADVANCED ZONE B SETTINGS
1 Level Control Variable
2 Fixed Level +15 dB
3 Zone ID
3 Zone ID
4 V2 Output
5 Link Input to Zone A
6 Link Power to Zone A
next item adjust
MENU advanced setup
ZB ZONE ID
From Front Panel
(UP) or (DOWN)
VOLUME KNOB
Variable
+15 dB
2
Tape
Tape
No
No
adjust
TAPE
From Front Panel
(UP) or (DOWN)
VOLUME KNOB
67
2
2
Tape
No
No
2
Action
move to Zone ID
adjust Zone 2 (B) ID to desired value
ADVANCED ZONE B SETTINGS
1 Level Control Fixed
2 Fixed Level +15 dB
3 Zone ID 2
4 V2 Output Line
4 V2 Output Line
5 Link Input to Zone A No
WARNING Connecting a tape
recorder to V2 in LINE mode
can cause speaker damage
next item adjust
MENU advanced setup
ZB V2 OUT LINE
Action
move to V2 Output
set for Tape or Line