Choosing A Source; Am/Fm Tuner - B&K Reference 50 Owner's Manual

CHOOSING A SOURCE

In general, the selected source will appear at the Zone 1 output, the TAPE output, and the V1 output. To prevent
feedback, TAPE input will not appear at TAPE output and V1 input will not appear at V1 output.
D V D A n a 2 . 0 4 8 K B o t h V i d e o
P L I I
From Remote From Front Panel
MAIN
desired Source
(SOURCE) step to source
Note: if your source has separate ON and OFF control like your processor, pressing the source button twice will
also turn on that source. If not, you will have to hit POWER while the remote is still set to the desired source.
TAPE MONITOR - If you have an analog three-head cassette or reel-to-reel analog tape recorder you may wish
to use TAPE MONITOR, which allows you to hear exactly what is on the tape as you are recording.
T A P E A n a 2 . 0 4 8 K B o t h V i d e o
P L I I
From Remote From Front Panel
desired Source (SOURCE) step to source
TAPE (SOURCE) step quickly to TAPE
Note: The tape monitor loop only allows recording of the analog inputs. If you simply choose the source you wish
to tape without selecting the TAPE MONITOR then you are able to make an analog recording from either the
analog or digital inputs.

AM/FM TUNER

F M 8 7 . 9 2 . 0 4 8 K B o t h V i d e o
P L I I
From Remote
1 B&K
2 AM or FM
3 TUNE+ or TUNE-
4 SEL or ENTER
Note: For a few seconds after performing any tuner operation ( AM, FM, or TUNE+/-) you may directly enter a
frequency from the remote control's numeric keypad. In addition, selecting between mono and stereo may be
activated from selecting the following on the remote: MAIN, B&K, PAGE, then select MONO or STEREO.
M o v 7 V a r i a b l e
M u s 7 V a r i a b l e
M u s 7 V a r i a b l e
From Front Panel
(SOURCE) step to AM or FM
(UP) or (DOWN)
(ENTER)
D V D A n a 2 . 0
Action
return control to processor
select desired source - remote now controls source
T A P E A n a 2 . 0
Action
select desired source or TUNER
source will appear on TAPE and V1 outs
wait a few seconds while processor analyzes
selected source
select TAPE MONITOR
TAPE will appear on Zone 1 out
F M 1 0 2 . 5 2 . 0
Action
make sure remote is in B&K mode
select desired TUNER Band
manually tune up or down to desired frequency
see AM/FM TUNER SETTING for DIRECT /
SEEK / TUNE
set FM stereo/mono
46
4 8 k
4 8 k
4 8 k