Factory Reset - B&K Reference 30 Owner's Manual

From Remote
­ V
1
(PAUSE) or (STOP)
ˆ ‡
2
(REW) or (FF)
RS-232 receive ID -
From Remote
­ V
1
(PAUSE) or (STOP)
ˆ ‡
2
(REW) or (FF)
RS-232 transmit ID -
From Remote
­ V
1
(PAUSE) or (STOP)
ˆ ‡
2
(REW) or (FF)
3 MENU
4 MENU
5 MENU
After completing all of your advanced settings you may wish to backup the settings. Refer to Memory
Backup/Restore under the MAIN MENU or see the Setup section of this manual

FACTORY RESET

Should you ever need to completely reset the processor to the original factory settings from the front panel press
the SLEEP, DOWN, and MENU buttons simultaneously. The processor will perform a complete reset and
erase all user programmed presets, menu settings, and the memory backup if you have performed one.
From Front Panel
(UP) or (DOWN)
VOLUME KNOB
RS-232 PORT SETUP
1 Port
2 Baud Rate
3 Echo
4 Update
5 Receive ID 5 Receive ID
6 Transmit ID
next item
MENU advanced setup
From Front Panel
(UP) or (DOWN)
VOLUME KNOB
RS-232 PORT SETUP
1 Port
2 Baud Rate
3 Echo
4 Update
5 Receive ID
6 Transmit ID 6 Transmit ID
move to new line
next item
MENU advanced setup
From Front Panel
(UP) or (DOWN)
VOLUME KNOB
MENU
MENU
MENU
75
Action
move to Update
select Enable or Disabled
Enable
9600
Enable
Enable
0 0
0
SEL select
Action
move to Receive ID
select desired receive ID
Enable
9600
Enable
Enable
0
0 0
SEL select
Action
move to Transmit ID
select desired transmit ID
return to ADVANCED SYSTEM SETUP
return to SYSTEM SETUP
return to MAIN MENU
p/n 12857 Rev. 0717A