Chapter 2. Initial Setup; Introduction; Navigating Through The User Program - GE DigitalFlow GS868 Startup Manual

Chapter 2. Initial Setup

2.1 Introduction

This chapter provides instructions for entering the minimum amount of programming data required to place the Model
GS868 flowmeter into operation. Before the Model GS868 can begin taking measurements and displaying valid data,
the current system and pipe parameters must be entered. In addition, a 2-Channel meter requires that each channel be
activated prior to use. Additional programming options provide access to the more advanced features of the Model
GS868, but this information is not required to begin taking measurements.
Note: See the Programming Manual for information on those User Program options not covered in this chapter.

2.2 Navigating Through the User Program

In order to begin using the Model GS868, the following submenus within the User Program will be accessed:
• ACTIV
- enables selection of the desired measurement method (for a 2-Channel meter, it is also used to activate a
channel)
• SYSTM
- prompts the user to enter the required system data
•
PIPE
- prompts the user to enter the required pipe parameters
As a guide in following the programming instructions in this chapter, the relevant portions of the Model GS868 menu
map have been reproduced in Figure 12 on page 33.
Note: There are minor differences at the start of the
models, but the
The following discussion assumes that the left screen pane is active. If the right screen pane is active, only the function
key designations change. That is, replace
Data Records.
Use the keypad, as described in the Programming Manual, to navigate through the User Program. The menu map may
be followed in sequence, or the  ] and  ] keys may be used to scroll through the prompt screens. The 
be used to delete the last alphanumeric character that was entered from the keypad.
DigitalFlow™ GS868 Startup Guide
PIPE
submenus are identical.
[F1]-[F4]
ACTIV SYSTM
and submenus for the 1-Channel and 2-Channel
[F5]-[F8]
with . Be sure to record all programming data in Appendix B,
Chapter 2. Initial Setup
key may
]
23