Table Of Contents - Azden 500UDR User Manual

TABLE OF CONTENTS

EXPLODED VIEW of 500UDR ................................................................................................ i
INTRODUCTION ...................................................................................................................... ii
RECEIVER SETUP .................................................................................................................. 1
Powering the receiver with batteries ........................................................................................... 1
Powering the receiver from the camera ...................................................................................... 1
Attaching the receiver to the camera with Velcro ......................................................................... 1
Attaching the Antennas ............................................................................................................... 1
Connecting the Output Cable ..................................................................................................... 1
INDICATORS AND CONTROLS ........................................................................................... 3-4
Multiple Frequency Example ..................................................................................................... 4
UHF FREQUENCY CHART ..................................................................................................... 4
500UDR TROUBLESHOOTING ............................................................................................... 5
51HT ......................................................................................................................................... 6
51BT ......................................................................................................................................... 7
51XT ...................................................................................................................................... 8-9
OPERATING THE SYSTEM ................................................................................................ 9-10
SPECIFICATIONS ................................................................................................................. 11
LICENSING ........................................................................................................................... 11
iii
(6) LED INDICATORS
The POWER LED turns green when power is turned "On" or red if battery level is low. If this LED
lights up red replace the battery.
The AF PEAK LED lights up if the input level is set to high, indicating the onset of distortion. Lower
the input level so that the AF PEAK LED lights only occasionally.
To plug the 51XT onto a microphone (low impedance with XRL connector) first make certain the
locking-ring is turned fully up (rotate counterclockwise). Then plug the 51XT fully into the
microphones XLR connector and tighten by rotating the ring fully down (clockwise).
OPERATING THE SYSTEM:
Because this a frequency agile system, meaning that you choose the frequency of
both the transmitter and receiver via the group and channel controls, we cannot
stress enough that any transmitter/receiver pair that you want to transmit and receive
on MUST BE SET TO THE SAME FREQUENCY!
Additionally, multiple systems used in the same proximity must ALL BE ON THE
SAME GROUP SELECTION! To change the frequency that a transmitter/receiver
pair is already on YOU MUST TURN OFF BOTH TRANSMITTER AND RECEIVER
FIRST!
Do not place the receiver on a metal surface, and avoid obstructions between the
receiver and transmitter, since this could degrade the performance of the equipment.
First, make sure that the power to all your components is turned off. Connect an
audio cable from the output of the receiver (1/4 or XLR) to a mic/line input on your
audio mixer or amplifier. Plug the receiver's AC adapter into the 12V input jack on
the receiver and then plug it into the AC electrical outlet. With the volume of your
mixer or amplifier set to minimum level, turn your system's power on. Turn on the
transmitter(s). Make sure all LEDs on the receiver(s) and transmitter(s) are operating
as described in the preceding pages. Now set the receivers volume to the midway
point and adjust the volume level on your mixer or amplifier.
9