Table of Contents
Advertisement
AXIS 7100 User's Guide
Connecting the WORKiO Copier
Caution!
•
Check that the power supply included with your AXIS 7100 is marked with the correct voltage.
•
Make sure that the external power supply to the AXIS 7100 is disconnected before connecting
and disconnecting to other units.
1. Switch off the WORKiO copier and disconnect the AXIS 7100 external power
supply.
2. Connect AXIS 7100 to the WORKiO copier using a fully connected parallel cable.
Connecting the AXIS 7100 to the network
1. Connect your AXIS 7100 to the network. The AXIS 7100 is designed for 10 Mbps
Ethernet and 100 Mbps Fast Ethernet networks and connects to the network via
a twisted pair category 5 cable (10baseT and 100baseTX).
2. Switch on the WORKiO copier.
3. Connect the external power supply to the AXIS 7100. The network indicator will
flash during power up and self test. The following message will appear on the
display during self test (stating the software version number, e.g. 1.00):
Note:
The tri-colored Network indicator flashes:
•
yellow - indicating network activity on a 10MB Ethernet network.
•
green - indicating network activity on a 100MB Fast Ethernet network.
•
red -indicating that the unit is not correctly connected to the network.
Basic Installation
11
Advertisement
Table of Contents
