Connecting Cd-Rom Drives To The Axis Cd-Rom Server - Axis 950 User Manual

Section 2: Basic Installation

Connecting CD-ROM Drives to the Axis CD-ROM Server

Before you begin
10
6. Connect power to the Axis CD-ROM server. The CD-ROM
server indicators will flash during power-on and self-test. When
the STATUS indicator stops flashing and remains unlit, the CD-
ROM server is ready for use.
If you intend to connect more CD-ROM drives to the Axis 851 or
951 CD-ROM server, the internal SCSI termination of the CD-
ROM server has to be turned off. To do this, the CD-ROM server has
to be connected to the network and configured. Proceed with
"Connecting the Axis CD-ROM Server to the Network" on page 14
and then with sections 3, 4 and 5. After turning internal SCSI
termination off according to the instructions in section 5, return to
"Connecting CD-ROM drives to the Axis CD-ROM Server" below.
Up to seven SCSI CD-ROM drives can be serviced by a single Axis
CD-ROM Server. The drives are connected using the appropriate
SCSI cable, which must be ordered separately.
• Make sure that the power supply is marked with the correct mains
voltage.
• Always make sure the power is not connected to the CD-ROM
server or any of the CD-ROM drives when making changes to the
SCSI chain.
• If you are using an AXIS 851 or AXIS 951 CD-ROM server with
an internal drive, make sure the internal termination is off. See
section 5.
1. Connect the SCSI cable to the external connector on the CD-
ROM server.
2. Connect the SCSI cable to the external drive.
AXIS 850/950 User's Manual