Synchronizing - BMW R nineT 2015 Rider's Manual

Logging on remote
5
control
50
Deactivate alarm function.
Switch on ignition.
Press button 2 three times.
Acknowledgment tone sounds
once.
Switch off ignition within ten
seconds.
Press button 2 three times.
Acknowledgment tone sounds
once.
z
Switch on ignition within ten
seconds.
Acknowledgment tone sounds
twice.
You can log on a maximum of
4 remote controls for the DWA.
The logon for each remote con-
trol is carried out in three steps.
Press and hold button 1 and
button 2.
LED flashes for ten seconds.
As soon as the LED goes out,
release button 1 and button 2.
LED lights up.
Press button 1 or button 2.
Alarm tone sounds once.
LED goes out.
Remote control is logged on.
Repeat the three previous work
steps for each additional re-
mote control.
Logon ended
The logon is ended if
4 remote controls have been
logged on
the ignition is switched off
no button was pressed for 30
seconds after the ignition was
switched off
no button was pressed for 30
seconds after a remote control
was logged on
After the logon is completed, the
LED flashes and the acknowledg-
ment tone sounds three times.

Synchronizing

with anti-theft alarm system
(DWA) OE
When is it necessary to
synchronize the remote
control?
The remote control must be syn-
chronized when the buttons of
the remote control has been op-
erated more than 256x outside
the range of the receiver. In this
case, the receiver on the mo-
torcycle no longer reacts to the
signals of the remote control.