Steps
1. Align and place the palm-rest assembly under the hinges of the display assembly.
2. Replace the six (M2.5x3) screws that secure the display assembly to the system.
3. Connect the display and camera cable to the connector on the system board.
Next steps
1. Install the
base
cover.
2. Install the
SIM card
tray.
3. Install the
SD
card.
4. Exit
service
mode.
5. Follow the procedure in
Battery
Removing the battery
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
SIM card
4. Remove the
base
cover.
5. Remove the
WWAN
card.
NOTE:
If battery was disconnected from system board for service, there will be a delay during system boot-up as the
system will undergo RTC battery reset.
After working on your
computer.
before working inside your
tray.
computer.
Removing and installing components
33